VoiceGuide IVR Software Main Page
Jump to content

Creative Labs Modem Blaster

Recommended Posts

I finally got the modem to pickup and answer run through the modules but when I try to enter numbers the modem is not hearing them. The touch tones are not being picked up. the old modem worked for this but needed to replace it because it did not have Caller ID. any help?

Share this post


Link to post

Some modems just do not detect tones very well when a sound file is played by the modem at the same time - but we have not yet come across any that do not detect tones at all.

 

Can you try calling from a different phone?

 

Ultimately the best solution is to get a Dialogic card...

Share this post


Link to post

Yes I have tried two different phones and a cell phone, waited for the sound file to stop and "listen" for tones but when I press them in it responds with nothing. Does not even blink the log file. I did notice that the inband was not enabled... does this matter? It showed up in the log...

 

P.S. I am evaluating the Dialogic cards now... What is the opinion on Retorex?

Share this post


Link to post
I did notice that the inband was not enabled

That does not affect DTMF detection - it has to do with PBX signaling at beginning of call.

What is the opinion on Retorex?

Retorex is not supported.

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×