Guest John SCI Report post Posted 01/20/2006 05:41 AM I downloaded all Intel software/drivers for my Dialog/4 ISA card. The card would initialize fine with the GENLOAD driver in Win98 prior to downloading the "newer" software. Now, I cannot even initialize the card as the firmware now reports as "version 0.0." Where can I download the firmware to where my card can be read? Thanks, John Share this post Link to post
SupportTeam Report post Posted 01/20/2006 05:44 AM Your only option is to contact Intel. As the card would be out of warranty it'd probably be cheaper to buy a new card. Share this post Link to post
Guest John SCI Report post Posted 01/20/2006 06:21 AM Actually, I purchased this board in 1996 when it was Dialogic. It has a lifetime warranty. A little more information: I downloaded the system release 5.1.1 for Windows and I re-read it...it states that the boards will shut down after 10 hours of use. Any place that my original firmware might have been dumped to? Thanks! Share this post Link to post
SupportTeam Report post Posted 01/20/2006 06:55 AM The 10 hour limit applies to some FP1 and onwards releases. Have you tried using the old version the drivers - like the 5.1.1 itself? Share this post Link to post
Guest John SCI Report post Posted 01/20/2006 08:44 AM I believe it was the 5.1.1 driver(s) and software which zapped my firmware...I'll check it again though. Thanks! Share this post Link to post
Guest John SCI Report post Posted 01/20/2006 11:01 AM OK, I downloaded the 5.1.1 file (phew) and I don't see a "no-brainer" way to reflash the firmware. Is there a utility I should be looking for? I've run the Intel Dialogic Configuration Manager with the same settings that worked yesterday (as well as changing the IRQ to others) with no luck...I've also run the Universal Diagnostic Utility...it finds a board but reports the following: System Download .... ERROR from pCTBB_SetCLientParm (bus type support level): CTBB_ERROR_INVALID_CLIENT_TYPE: Client type (technology) invalid D/41D (addr D000) Download .. Firmware Version 0.00 1 Dialogic Board Successfully Installed ................... Download failure: Type: Dialog/4, ID: 0xD000. Results buffer: 0x000 0x0061 0x0001 0x0013 0xFFF 0x00FF 0x00FF 0x0005 Marking board dead. .................................... Any ideas???? Thanks, John Share this post Link to post
SupportTeam Report post Posted 01/20/2006 11:09 PM You should be contacting Intel about these types of errors. Share this post Link to post
